Anritsu MS2840A - [:SENSe]:SPURious[:RANGe][:LIST]:FREQuency:STOP <freq_1>,<freq_2>,<freq_3>,<freq_4>,<freq_5>,<freq_6>,<freq_7>,<freq_8>,<freq_9>,<freq_10>,<freq_11>,<freq_12>,<freq_13>,<freq_14>,<freq_15>,<freq_16>,<freq_17>,<freq_18>,<freq_19>,<freq_20>

Chapter 2 SCPI Device Message Detail
2-738
[:SENSe]:SPURious[:RANGe][:LIST]:FREQuency:STOP
<freq_1>,<freq_2>,<freq_3>,<freq_4>,<freq_5>,<freq_6>,<freq_7>,<freq_8>,
<freq_9>,<freq_10>,<freq_11>,<freq_12>,<freq_13>,<freq_14>,<freq_15>,<fr
eq_16>,<freq_17>,<freq_18>,<freq_19>,<freq_20>
Spurious Emission Stop Frequency
Function
This command sets the stop frequency of each segment.
Command
[:SENSe]:SPURious[:RANGe][:LIST]:FREQuency:STOP <freq_n>
Parameter
<freq_n>
Stop frequency of Segment n
[MS269xA]
–99.9997 MHz to 6.05 GHz (MS2690A)
–99.9997 MHz to 13.6 GHz (MS2691A)
–99.9997 MHz to 26.6 GHz (MS2692A)
[MS2830A]
–99.9997 MHz to 3.7 GHz (Option 040)
–99.9997 MHz to 6.1 GHz (Option 041)
–99.9997 MHz to 13.6 GHz (Option 043)
–99.9997 MHz to 26.6 GHz (Option 044)
–99.9997 MHz to 43.1 GHz (Option 045)
[MS2840A]
–99.9997 MHz to 3.7 GHz (Option 040)
–99.9997 MHz to 6.1 GHz (Option 041)
–99.9997 MHz to 27 GHz (Option 044)
–99.9997 MHz to 45 GHz (Option 046)
Resolution 1 Hz
Suffix Code HZ, KHZ, KZ, MHZ, MZ, GHZ, GZ
Hz is used when omitted.
Default
[MS269xA]
Segment 1 150 kHz
Segment 2 30 MHz
Segment 3 1 GHz
Segment 4 2 GHz
Segment 5 3 GHz
Segment 6 4 GHz
Segment 7 5 GHz
Segment 8 6 GHz
Segment 9 7 GHz (6 GHz for MS2690A)
Segment 10 8 GHz (6 GHz for MS2690A)
Segment 11 9 GHz (6 GHz for MS2690A)
Segment 12 10 GHz (6 GHz for MS2690A)