Anritsu MS2840A - :CONFigure:TOI; :INITiate:TOI

Chapter 2 SCPI Device Message Detail
2-844
:CONFigure:TOI
TOI Configure
Function
This command turns on the TOI measurement.
Command
:CONFigure:TOI
Details
No measurement is made.
Example of Use
To turn on the TOI measurement.
CONF:TOI
:INITiate:TOI
TOI Initiate
Function
This command starts the TOI measurement.
Command
:INITiate:TOI
Details
When this function is executed, the TOI turns on and the measurement
is started.
To read out the measurement results after executing this command,
perform the synchronization control using the “*WAI” command.
Example of Use
To start the TOI measurement.
INIT:TOI