Anritsu MS2840A - [:SENSe]:CHPower:SWEep:POINts <integer>; [:SENSe]:CHPower:SWEep:POINts?; [:SENSe]:CHPower:SWEep:TIME <time>

2.11 Channel Power
2-523
2
SCPI Device Message Details
[:SENSe]:CHPower:SWEep:POINts <integer>
Trace Point
Function
This command sets the number of the trace display points.
Refer to
[:SENSe]:SWEep:POINts.
Related command
This command has the same function as the following commands.
[:SENSe]:SWEep:POINts
[:SENSe]:ACPower:SWEep:POINts
[:SENSe]:OBWidth:SWEep:POINts
[:SENSe]:CHPower:SWEep:POINts?
Trace Point Query
Function
This command queries the number of the trace display points.
Refer to
[:SENSe]:SWEep:POINts?.
Related command
This command has the same function as the following commands.
[:SENSe]:SWEep:POINts?
[:SENSe]:ACPower:SWEep:POINts?
[:SENSe]:OBWidth:SWEep:POINts?
[:SENSe]:CHPower:SWEep:TIME <time>
Sweep Time
Function
This command sets the sweep time.
Refer to
[:SENSe]:SWEep:TIME.
Related command
This command has the same function as the following commands.
[:SENSe]:SWEep:TIME
[:SENSe]:ACPower:SWEep:TIME
[:SENSe]:OBWidth:SWEep:TIME
[:SENSe]:BPOWer|:TXPower:SWEep:TIME