Anritsu MS2840A - :CONFigure:OBWidth; :INITiate:OBWidth

Chapter 2 SCPI Device Message Details
2-540
:CONFigure:OBWidth
Occupied Bandwidth Configure
Function
This command sets OBW measurement to On.
Command
:CONFigure:OBWidth
Details
No measurement is performed.
Example of Use
To set OBW measurement to On.
CONF:OBW
:INITiate:OBWidth
Occupied Bandwidth Initiate
Function
This command starts OBW measurement.
Command
:INITiate:OBWidth
Details
OBW measurement is set to On and the measurement starts, when this
function is executed.
To read out the measurement results after executing this command,
perform the synchronization control using the “*WAI” command.
Example of Use
To initiate OBW measurement.
INIT:OBW