Anritsu MS2840A - :TRIGger[:SEQuence]:EXTernal[1]:SLOPe?

2.7 Sweep/Trigger/Gate
2-279
2
SCPI Device Message Details
:TRIGger[:SEQuence]:EXTernal[1]:SLOPe?
Trigger Slope Query
Function
This command queries the trigger detection mode (rise/fall).
Query
:TRIGger[:SEQuence]:EXTernal[1]:SLOPe?
Response
<mode>
Parameter
<mode>
Trigger detection mode
POS
Detects at the rising edge
NEG
Detects at the rising edge
Details
This function queries the detection mode for the trigger when the trigger
signal source is video detection (Video), wide bandwidth IF detection
(Wide IF Video), external input (External), SG marker (SG Marker), or
Baseband Interface (BBIF).
Example of Use
To query the trigger detection mode.
TRIG:EXT:SLOP?
> POS
Related command
This command has the same function as the following commands.
:TRIGger[:SEQuence]:WIF|:RFBurst:SLOPe?
:TRIGger[:SEQuence]:VIDeo:SLOPe?