Anritsu MS2840A - [:SENSe]:SEMask:BANDwidth[1][:RESolution]:AUTO ON|OFF|1|0

Chapter 2 SCPI Device Message Details
2-600
[:SENSe]:SEMask:BANDwidth[1][:RESolution]:AUTO ON|OFF|1|0
Spectrum Emission Mask Resolution Bandwidth Auto/Manual
Function
This command enables/disables the automatic resolution bandwidth
(RBW) setting function for the reference channel for Spectrum Emission
Mask measurement.
Command
[:SENSe]:SEMask:BANDwidth[1][:RESolution]:AUTO <switch>
Parameter
<switch>
Automatic resolution bandwidth (RBW) setting
function On/Off state
ON|1
Enables the automatic resolution bandwidth
setting function.
OFF|0
Disables the automatic resolution bandwidth
setting function.
Details
The setting range of this function is limited depending on the settings of
other parameters. Refer to the
MS2690A/MS2691A/MS2692A Signal
Analyzer Operation Manual (Spectrum Analyzer Function Operation)
or
MS2830A/MS2840A Signal Analyzer Operation Manual (Spectrum
Analyzer Function Operation)
for details.
Example of Use
To enable the automatic resolution bandwidth setting function for the
reference channel.
SEM:BAND:AUTO ON