Anritsu MS2840A - [:SENSe]:SWEep:TIME:AUTO:MODE?

Chapter 2 SCPI Device Message Details
2-258
Parameter
<mode>
Sweep time
FAST
Fast sweep mode (MS2830A, MS2840A Default)
NORMal
Normal sweep mode (MS269xADefault)
Details
This command is not available during the Spectrum Emission Mask
measurement.
Example of Use
To set the sweep time to normal sweep mode.
SWE:TIME:AUTO:MODE NORM
[:SENSe]:SWEep:TIME:AUTO:MODE?
Auto Sweep Time Mode Query
Function
This command queries the sweep mode (Fast or Normal) when the
automatic sweep time setting function is enabled.
Query
[:SENSe]:SWEep:TIME:AUTO:MODE?
Response
<mode>
Parameter
<mode>
Sweep time
FAST
Fast sweep mode
NORM
Normal sweep mode (Default)
Example of Use
To query the sweep mode.
SWE:TIME:AUTO:MODE?
> NORM