Anritsu MS2840A - SMZ;SMZ?

Chapter
４
Native Device Message Details
4-270
SMZ/SMZ?
Write and Query Trace Data (Gate View)
Function
This command writes and queries the trace data for Gate View. This
command targets negative detection trace data when the detection mode
is Positive & Negative (Normal mode).
Command
SMZ wpoint,data
Query
SMZ? start,number
Response
data1,data2,...
Parameter
wpoint
Specify the writing position as the number of
displayed points from the left edge of the screen.
Range 0 to 10, 20, 40, 50, 100, 200, 250, 400, 500,
1000, 2000, 5000, 10000, 30000 (MS269xA Only)
data
Level data to be written
Resolution Integers in 0.001 dB units (on log scale).
{ Voltage value (V)/reference level (V) }
×
10000
(At linear scale)
start
Specify the loading start position as the number
of displayed points from the left edge of the
screen.
Range 0 to 10, 20, 40, 50, 100, 200, 250, 400, 500, 1000,
2000, 5000, 10000, 30000 (MS269xA Only)
number
Number of items of data to be loaded
Range 1 to 11, 21, 41, 51, 101, 201, 251, 401, 501, 1001,
2001, 5001, 10001, 30001 (MS269xA Only)
Details
This command is not available when Gate View is set to Off.
Example of Use
To set
−
20 dBm at the 1st point and
−
21 dBm at the 2nd point.
SMZ 1,-20000
SMZ 2,-21000
SMZ? 1,2
> -20000,-21000