Anritsu MS2840A - [:SENSe]:MIXer:SIGNal:MODE?

2.21 Setting External Mixer
2-1005
2
SCPI Device Message Details
[:SENSe]:MIXer:SIGNal:MODE?
Signal Identifier Mode Query
Function
This command queries the type of signal identifier operation, which
identifies measured signal and image signal when external mixer is used.
Query
[:SENSe]:MIXer:SIGNal:MODE?
Response
<type>
Parameter
<type>
Signal Identifier Mode
ISH
Displays the sweep results of different polarities
alternately.
ISUP
Displays the sweep results of different polarities
after Minimum processing.
Details
This function is available when Option 044/045 is installed for MS2830A.
This function is available when Option 044/046 is installed for MS2840A.
Example of Use
To query the type of signal identifier operation, which identifies
measured signal and image signal.
MIX:SIGN:MODE?
> ISH