Anritsu MS2840A - PRL

Chapter
４
Native Device Message Details
4-190
[Common]
The frequency to be switched to the preselector band can be set by using
Frequency Band Mode.
Automatic setting of the peaking bias value cannot be used during
Spurious measurement and when Displayed Segment Mode is Auto.
Example of Use
To set the peaking bias value automatically.
PRESEL PRESET
PRESEL?
> 0
PRL
Peak to Reference Level
Function
This command sets the maximum peak point to the reference level.
Command
PRL
Example of Use
To set the maximum peak point to the reference level.
PRL