Anritsu MS2840A - [:SENSe]:POWer[:RF]:ATTenuation?

Chapter 2 SCPI Device Message Details
2-60
[:SENSe]:POWer[:RF]:ATTenuation?
RF Attenuator Query
Function
This command queries the attenuation.
Query
[:SENSe]:POWer[:RF]:ATTenuation?
Response
<rel_ampl>
Parameter
<rel_ampl>
Attenuation
Range 0 to 60 dB
Resolution
[MS269xA]
2 dB
[MS2830A]
,
[MS2840A]
2 dB or 10 dB
Refer to “Table 2.4.2-3 Resolution of Input Attenuator” in the
MS2830A/MS2840A Signal Analyzer Operation Manual
(Spectrum Analyzer Function Operation)
.
Suffix code None. Value is returned in dB units.
Example of Use
To query the attenuation.
POW:ATT?
> 10