Anritsu MS2840A - :TRIGger[:SEQuence]:FRAMe:SYNC?

Chapter 2 SCPI Device Message Details
2-290
:TRIGger[:SEQuence]:FRAMe:SYNC?
Frame Sync Source Query
Function
This command queries the synchronization signal source for frame
trigger start.
Query
:TRIGger[:SEQuence]:FRAMe:SYNC?
Response
<sync>
Parameter
<sync>
Synchronized signal source
EXT
External input
IMM
Free run
WIF
Wideband IF detection (Wide IF Video)
Details
This command is not available for MS269x Series.
This setting is shared by the trigger signal and gate signal. The same
value is also used when frame trigger is selected as the gate signal source
for gate sweep.
Example of Use
To query the frame trigger synchronized signal source.
TRIG:FRAM:SYNC?
> WIF