Anritsu MS2840A - [:SENSe]:SPURious:TDOMain[:RANGe][:LIST]:SWEep:TIME <seconds_1>,<seconds_2>,<seconds_3>,<seconds_4>,<seconds_5>,<seconds_6>,<seconds_7>,<seconds_8>,<seconds_9>,<seconds_10>,<seconds_11>,<seconds_12>,<seconds_13>,<seconds_14>,<seconds_15>,<seconds_16>...

2.14 Spurious Emission Measurement Function
2-791
2
SCPI Device Message Details
[:SENSe]:SPURious:TDOMain[:RANGe][:LIST]:SWEep:TIME
<seconds_1>,<seconds_2>,<seconds_3>,<seconds_4>,<seconds_5>,<seco
nds_6>,<seconds_7>,<seconds_8>,<seconds_9>,<seconds_10>,<seconds_
11>,<seconds_12>,<seconds_13>,<seconds_14>,<seconds_15>,<seconds_
16>,<seconds_17>,<seconds_18>,<seconds_19>,<seconds_20>
Spurious Emission Time Domain Sweep Time
Function
This command sets the sweep time in Time Domain Setup.
Command
[:SENSe]:SPURious:TDOMain[:RANGe][:LIST]:SWEep:TIME
<seconds_n>
Parameter
<seconds_n>
Sweep time
Range 1
µ
s to 1000 s (For Time-axis measurement)
Suffix Code NS,US,MS,S
S is used when omitted.
Default Auto value
Example of Use
To set the sweep time in Time Domain Setup.
SPUR:TDOM:SWE:TIME
0.1,0.1,0.1,0.1,0.1,0.1,0.1,0.1,0.1,0.1,0.2,0.3,0.1,0.1,
0.1,0.1,0.1,0.1,0.1,0.1