Anritsu MS2840A - CALC:MARK:PEAK:SORT:X; CALC:MARK:PEAK:SORT:Y

Chapter
４
Native Device Message Details
4-46
CALC:MARK:PEAK:SORT:X
Search Peaks Sort X
Function
This command sorts as many markers as the number set in Search Peaks
Number by frequency (time) on the trace.
Command
CALC:MARK:PEAK:SORT:X
Details
This command is not available in the following cases:
•
During the Spurious Emission measurement.
•
When Displayed Segment Mode is set to Auto.
•
During the Spectrum Emission Mask measurement.
•
When the active trace is set to Blank.
Example of Use
To sort the markers by frequency.
CALC:MARK:PEAK:SORT:X
CALC:MARK:PEAK:SORT:Y
Search Peaks Sort Y
Function
This command sorts as many markers as the number set in Search Peaks
Number by level on the trace.
Command
CALC:MARK:PEAK:SORT:Y
Details
This command is not available in the following cases:
•
During the Spurious Emission measurement.
•
When Displayed Segment Mode is set to Auto.
•
During the Spectrum Emission Mask measurement.
•
When the active trace is set to Blank.
Example of Use
To sort the markers by level.
CALC:MARK:PEAK:SORT:Y