Chapter 2 SCPI Device Message Details
2-270
:CALCulate:DETector[:FUNCtion]?
Detection Mode Query
Function
This command selects the detection mode of the waveform pattern.
When Couple Time/Freq. Domain is set to Off, each parameter is
specified in accordance with the already-specified frequency axis or time
axis measurement. Refer to
[:SENSe]:DETector[:FUNCtion]?
Related command
This command has the same function as the following commands.
[:SENSe]:DETector[:FUNCtion]?
[:SENSe]:ACPower:DETector[:FUNCtion]?
[:SENSe]:CHPower:DETector[:FUNCtion]?
[:SENSe]:OBWidth:DETector[:FUNCtion]?
:CALCulate:ACPower:DETector[:FUNCtion]?
:CALCulate:CHPower:DETector[:FUNCtion]?
:CALCulate:OBWidth:DETector[:FUNCtion]?
:TRIGger[:SEQuence][:STATe] ON|OFF|1|0
Trigger Switch
Function
This command sets the trigger sweep to On/Off.
Command
:TRIGger[:SEQuence][:STATe] <switch>
Parameter
<switch>
Trigger sweep ON/OFF
OFF|0
Does not perform trigger sweep.
ON|1
Performs trigger sweep.
Details
This command is not available when Internal Signal Generator Control
On/Off is On.
Example of Use
To set to wait for a sweep trigger.
TRIG ON
To Next Page
Loading...
