Chapter 2 SCPI Device Message Details
2-680
> ABS,ABS,ABS,ABS,ABS,ABS,ABS,ABS,ABS,ABS,ABS,ABS,OFF,OFF
Related command
This command has the same function as the following command.
[:SENSe]:SEMask:LOGic:OFFSet[1]:LIST:TEST?
:CONFigure:SEMask
Spectrum Emission Mask Configure
Function
This command sets Spectrum Emission Mask measurement to On.
Command
:CONFigure:SEMask
Details
No measurement is executed.
Example of Use
To set SEM measurement to On.
CONF:SEM
:INITiate:SEMask
Spectrum Emission Mask Initiate
Function
This command starts Spectrum Emission Mask measurement.
Command
:INITiate:SEMask
Details
Spectrum Emission Mask measurement is set to On and the
measurement is initiated, when this function is executed.
To read out the measurement results after executing this command,
perform the synchronization control using the “*WAI” command.
Example of Use
To start SEM measurement once.
INIT:SEM
To Next Page
Loading...
