Anritsu MS2840A - :CALCulate:BPOWer|:TXPower:MARKer[1]|2|3|4|5|6|7|8|9|10:MAXimum; :CALCulate:BPOWer|:TXPower:MARKer[1]|2|3|4|5|6|7|8|9|10:MAXimum:POWer

Chapter 2 SCPI Device Message Details
2-470
:CALCulate:BPOWer|:TXPower:MARKer[1]|2|3|4|5|6|7|8|9|10:MAXimum
Peak Search
Function
This command searches for the maximum level point of the active trace
and moves the marker point.
Refer to
:CALCulate:MARKer[1]|2|3|4|5|6|7|8|9|10:MAXimum.
Related command
This command has the same function as the following commands.
:CALCulate:MARKer[1]|2|3|4|5|6|7|8|9|10:MAXimum
:CALCulate:ACPower:MARKer[1]|2|3|4|5|6|7|8|9|10:MAXimum
:CALCulate:CHPower:MARKer[1]|2|3|4|5|6|7|8|9|10:MAXimum
:CALCulate:OBWidth:MARKer[1]|2|3|4|5|6|7|8|9|10:MAXimum
:CALCulate:BPOWer|:TXPower:MARKer[1]|2|3|4|5|6|7|8|9|10:MAXimum:PO
Wer
Power Peak Search
Function
This command moves the active marker to the position where the peak
power of the zone width of the active marker becomes maximum in the
measurement band.
Refer to
:CALCulate:MARKer[1]|2|3|4|5|6|7|8|9|10:MAXimum:POWer
Related command
This command has the same function as the following command.
:CALCulate:MARKer[1]|2|3|4|5|6|7|8|9|10:MAXimum:POWer
:CALCulate:ACPower:MARKer[1]|2|3|4|5|6|7|8|9|10:MAXimum:
POWer
:CALCulate:CHPower:MARKer[1]|2|3|4|5|6|7|8|9|10:MAXimum:
POWer
:CALCulate:OBWidth:MARKer[1]|2|3|4|5|6|7|8|9|10:MAXimum:
POWer
:CALCulate:SPURious:MARKer[1]|2|3|4|5|6|7|8|9|10:MAXimum
:POWer