Anritsu MS2840A - [:SENSe]:SEMask:OFFSet[1]:LIST:BANDwidth[1]:INTegration:AUTO <switch_1>[,<switch_2>[,<switch_3>[,<switch_4>[,<switch_5>[,<switch_6>[,<switch_7>[,<switch_8>[,<switch_9>[,<switch_10>[,<switch_11>[,<switch_12>]]]]]]]]]]]

2.13 Spectrum Emission Mask
2-651
2
SCPI Device Message Details
[:SENSe]:SEMask:OFFSet[1]:LIST:BANDwidth[1]:INTegration:AUTO
<switch_1>[,<switch_2>[,<switch_3>[,<switch_4>[,<switch_5>[,<switch_6>[,<
switch_7>[,<switch_8>[,<switch_9>[,<switch_10>[,<switch_11>[,<switch_12>]
]]]]]]]]]]
Spectrum Emission Mask Offset Integrate Bandwidth Auto/Manual
Function
This command enables/disables the automatic Integrate BW setting
function for the offset during Spectrum Emission Mask measurement.
Command
[:SENSe]:SEMask:OFFSet[1]:LIST:BANDwidth[1]:INTegration:
AUTO <switch_n>
Parameter
<switch_n>
Automatic Integrate BW setting function On/Off
for Offset-n
ON|1
Enables the automatic Integrate BW setting
function.
OFF|0
Disables the automatic Integrate BW setting
function.
Details
The setting range of this function is limited depending on the setting of
RBW of the target offset. Refer to the
MS2690A/MS2691A/MS2692A
Signal Analyzer Operation Manual (Spectrum Analyzer Function
Operation)
or MS2830A/MS2840A Signal Analyzer Operation Manual
(Spectrum Analyzer Function Operation)
for details.
This command is not available if Detection of the target offset is set to
any of the following:
•
Pos&Neg
•
Positive
•
Negative
•
Sample
Example of Use
To enable the automatic Integrate BW setting function for the offset.
SEM:OFFS:LIST:BAND:INT:AUTO
ON,ON,ON,ON,ON,ON,ON,ON,ON,ON,ON,ON