Anritsu MS2840A - [:SENSe]:POWer[:RF]:PADJust?

Chapter 2 SCPI Device Message Detail
2-958
[:SENSe]:POWer[:RF]:PADJust?
Pre-selector Tune Query
Function
This command queries the Preselector peaking bias value.
Query
[:SENSe]:POWer[:RF]:PADJust?
Response
<freq>
Parameter
<freq>
Peaking bias value
Range –128 to 127
Resolution 1
Details
[MS269xA]
Automatic setting of the peaking bias value cannot be used under the
following conditions:
•
When using the MS2690A:
•
When not using the preselector band:
The frequency which switched to the preselector band can be set in
Frequency Band Mode.
[MS2830A], [MS2840A]
Automatic setting of the peaking bias value cannot be used under the
following conditions:
•
MS2830A-040/041/043, MS2840A-040/041:
•
When not using the preselector band:
The frequency which switched to the preselector band can be set in
Frequency Band Mode.
Example of Use
To query the peaking bias value.
POW:PADJ?
> 100