Chapter
４
Native Device Message Details
4-31
4
Native Device Message Details
BAPWRSTOP/BAPWRSTOP?
Burst Average Power Stop Time
Function
This command sets the stop position (time) of burst average power
measurement.
Command
BAPWRSTOP time
Query
BAPWRSTOP?
Response
time
Suffix code None. Value is returned in µs units.
Parameter
time
Stop position (time)
Range Within trace display range
Resolution Formula for calculating the resolution is:
Sweep Time / (Trace Point – 1)
(Minimum value: 1 ns)
Suffix code NS, US, MS, S
MS is used when omitted.
Example of Use
To set the stop position (time) of burst average power measurement to
100 ms.
BAPWRSTOP 100MS
BAPWRSTART?
> 100000.000
To Next Page
Loading...
