Anritsu MS2840A - [:SENSe]:SEMask:AVERage[:STATe]?

Chapter 2 SCPI Device Message Details
2-704
[:SENSe]:SEMask:AVERage[:STATe]?
Storage Mode Query
Function
This command queries the storage mode for Trace A.
Query
[:SENSe]:SEMask:AVERage[:STATe]?
Response
<switch>
Parameter
<switch>
Setting of Storage Mode
1
Linear Average
0
Other than Linear Average
Example of Use
To query the storage mode for Trace A.
SEM:AVER?
> 0
Related command
This command has the same function as the following commands.
:TRACe[1]|2|3|4|5|6:STORage:MODE?
[:SENSe]:ACPower:AVERage[:STATe]?
[:SENSe]:CHPower:AVERage[:STATe]?
[:SENSe]:OBWidth:AVERage[:STATe]?
[:SENSe]:BPOWer|:TXPower:AVERage[:STATe]?
[:SENSe]:SPURious:AVERage[:STATe]?