Anritsu MS2840A - :CALCulate:SEMask:DETector[:FUNCtion] NORMal|POSitive|NEGative|SAMPle|RMS|AVERage

Chapter 2 SCPI Device Message Details
2-632
:CALCulate:SEMask:DETector[:FUNCtion]
NORMal|POSitive|NEGative|SAMPle|RMS|AVERage
Spectrum Emission Mask Detection Mode
Function
This command selects the detection mode of the waveform pattern when
measuring the reference power for Spectrum Emission Mask
measurement.
Command
:CALCulate:SEMask:DETector[:FUNCtion] <mode>
Parameter
<mode>
Detection mode selection
NORMal
Simultaneous positive and negative peak
detection (Default)
POSitive
Positive peak detection
NEGative
Negative peak detection
SAMPle
Sample detection
RMS|AVERage
RMS detection
Example of Use
To set the detection mode when measuring the reference power to
positive peak detection.
CALC:SEM:DET POS
Related command
This command has the same function as the following command.
[:SENSe]:SEMask:DETector[:FUNCtion]