Anritsu MS2840A - :INITiate:CONTinuous OFF|ON|0|1; :INITiate:CONTinuous?

Chapter 2 SCPI Device Message Details
2-250
:INITiate:CONTinuous OFF|ON|0|1
Continuous Measurement
Function
This command switches Single/Continuous of the sweep mode.
Command
:INITiate:CONTinuous <switch>
Parameter
<switch>
Sweep mode
0|OFF
Single measurement
1|ON
Continuous measurement (Default)
Example of Use
To execute the Continuous measurement.
INIT:CONT ON
:INITiate:CONTinuous?
Continuous Measurement Query
Function
This command queries the sweep mode.
Query
:INITiate:CONTinuous?
Response
<switch>
Parameter
<switch>
Sweep mode
0
Single measurement
1
Continuous measurement
Example of Use
To query the sweep mode.
INIT:CONT?
> 0