Chapter 2 SCPI Device Message Details
2-180
<time_n>
Peak time
Resolution 0.01 µs
Suffix code None. Value is returned in s units.
–999999999999 is returned when not measured or an error occurs.
Example of Use
To query the frequency and level of the active trace at once.
CALC:DATA:PEAK? –40.000,10.000
:CALCulate:MARKer:PEAK:SORT:Y
Search Peaks Sort Y
Function
This command sorts as many markers as the number set in Search Peaks
Number by level on the trace.
Command
:CALCulate:MARKer:PEAK:SORT:Y
Details
This command is not available in the following cases:
•
During the Spurious Emission measurement AND when Displayed
Segment Mode is set to Auto.
•
During the Spectrum Emission Mask measurement.
•
When Blank is set for the active trace.
Example of Use
To sort the markers by level.
CALC:MARK:PEAK:SORT:Y
To Next Page
Loading...
