Anritsu MS2840A - TS; TSAVG

Chapter
４
Native Device Message Details
4-351
4
Native Device Message Details
TS
Single Sweep
Function
This command sets the sweep mode to single and starts single sweep.
Command
TS
Details
Starting sweep with this function makes the following command wait
without being processed until sweep is finished.
Example of Use
To start single sweep.
TS
TSAVG
Average Sweep
Function
This command sets the storage mode to Average and starts sweep.
Command
TSAVG
Details
Starting sweep with this function makes the following command wait
without being processed until sweep is finished.
Example of Use
To set the storage mode to Average and start sweep.
TSAVG