Anritsu MS2840A - [:SENSe]:SEMask:LOGic:OFFSet[1]:LIST:TEST <logic_1>[,<logic_2>[,<logic_3>[,<logic_4>[,<logic_5>[,<logic_6>[,<logic_7>[,<logic_8>[,<logic_9>[,<logic_10>[,<logic_11>[,<logic_12>]]]]]]]]]]]

2.13 Spectrum Emission Mask
2-675
2
SCPI Device Message Details
[:SENSe]:SEMask:LOGic:OFFSet[1]:LIST:TEST
<logic_1>[,<logic_2>[,<logic_3>[,<logic_4>[,<logic_5>[,<logic_6>[,<logic_7>[,
<logic_8>[,<logic_9>[,<logic_10>[,<logic_11>[,<logic_12>]]]]]]]]]]]
Spectrum Emission Mask Fail Logic
Function
This command selects the judgment method of the offset for Spectrum
Emission Mask measurement.
Command
[:SENSe]:SEMask:LOGic:OFFSet[1]:LIST:TEST <logic_n>
Parameter
<logic_n>
Judgment method for offset n
OFF
Does not judge.
ABSolute
ABS1
Judges by using the absolute level upper limit 1.
RELative
REL
Judges by using the relative level upper limit.
AND
ABS1 and REL
Judges “AND” by using the absolute level upper
limit 1 and relative level upper limit.
OR
ABS1 or REL
Judges “OR” by using the absolute level upper
limit 1 and relative level upper limit.
AAND
(ABS1 and REL) and ABS2
Judges “AND” by using the absolute level upper
limit 1 and relative level upper limit. Judges
“AND” by using the result and the absolute level
upper limit 2.
AOR
(ABS1 or REL) and ABS2
Judges “OR” by using the absolute level upper
limit 1 and relative level upper limit. Judges
“AND” using the result and the absolute level
upper limit 2.
AND2
ABS1 and ABS2
Judges “AND” by using the absolute level upper
limit 1 and the absolute level upper limit 2.
Example of Use
To judge by using the absolute level upper limit 1.
SEM:LOG:OFFS:LIST:TEST
ABS,ABS,ABS,ABS,ABS,ABS,ABS,ABS,ABS,ABS,ABS,ABS