Anritsu MS2840A - SEM:OFFS:LIST:RLEV:AUTO;SEM:OFFS:LIST:RLEV:AUTO?

Chapter
４
Native Device Message Details
4-240
SEM:OFFS:LIST:RLEV:AUTO/SEM:OFFS:LIST:RLEV:AUTO?
Spectrum Emission Mask Offset Reference Level Auto/Manual
Function
This command sets the reference level of the offset for Spectrum
Emission Mask measurement automatically.
Command
SEM:OFFS:LIST:RLEV:AUTO
switch_1_com[,switch_2_com[,switch_3_com[,switch_4_com[,
switch_5_com[,switch_6_com[,switch_7_com[,switch_8_com[,
switch_9_com[,switch_10_com[,switch_11_com[,switch_12_co
m]]]]]]]]]]]
Query
SEM:OFFS:LIST:RLEV:AUTO?
Response
switch_1_res,switch_2_res,switch_3_res,switch_4_res,swit
ch_5_res,switch_6_res,switch_7_res,switch_8_res,switch_9
_res,switch_10_res,switch_11_res,switch_12_res
Parameter
switch_n_com
Automatic setting of Reference Level of Offset-n
ON|1
Enables the automatic setting function.
OFF|0
Disables the automatic setting function.
switch_n_res
Automatic setting of Reference Level of Offset-n
1
Automatic setting function is enabled.
0
Automatic setting function is disabled.
Details
The same value as the reference level in measuring the reference power
is used in the automatic setting.
Example of Use
To set the reference level of the offset automatically.
SEM:OFFS:LIST:RLEV:AUTO
ON,ON,OFF,OFF,ON,ON,ON,ON,OFF,OFF,ON,ON
SEM:OFFS:LIST:RLEV:AUTO?
> 1,1,0,0,1,1,1,1,0,0,1,1