Anritsu MS2840A - CALC:MARK:PEAK:SORT:COUN;CALC:MARK:PEAK:SORT:COUN?

Chapter
４
Native Device Message Details
4-45
4
Native Device Message Details
CALC:MARK:PEAK:SORT:COUN/CALC:MARK:PEAK:SORT:COUN?
Search Peaks Number
Function
This command sets the search number when Search Peaks Sort Y/X is
executed.
Command
CALC:MARK:PEAK:SORT:COUN integer
Query
CALC:MARK:PEAK:SORT:COUN?
Response
integer
Parameter
integer
Search number
Range 1 to 10
Resolution 1
Default 10
Details
This command is not available in the following cases:
•
During the Spurious Emission measurement and when Displayed
Segment Mode is set to Auto.
•
During the Spectrum Emission Mask measurement.
Example of Use
To set the search number to 6.
CALC:MARK:PEAK:SORT:COUN 6
CALC:MARK:PEAK:SORT:COUN?
> 6