Anritsu MS2840A - [:SENSe]:SWEep:EGATe:SOURce?

2.7 Sweep/Trigger/Gate
2-295
2
SCPI Device Message Details
[:SENSe]:SWEep:EGATe:SOURce?
Gate Source Query
Function
This command queries the gate signal source.
Command
[:SENSe]:SWEep:EGATe:SOURce?
Response
<source>
Parameter
<source>
Trigger signal source
[MS269xA]
EXT
External input (External)
IMM
Free run
WIF
Wideband IF detection (Wide IF Video)
SG
SG marker
BBIF
Baseband Interface (BBIF)
[MS2830A], [MS2840A]
EXT
External input (External)
IMM
Free run
WIF
Wideband IF detection (Wide IF Video)
SG
SG marker
FRAM
Frame period trigger
Details
[MS269xA]
SG marker trigger can be selected only when the Option 020/120 Vector
Signal Generator is installed.
BBIF trigger cannot be selected only when the Option 040/140 Baseband
Interface Unit is not installed or the software package is Ver.6.00.00 or
later.
[MS2830A], [MS2840A]
SG marker trigger can be selected only when the Option 020/120/021/121
Vector Signal Generator is installed.
Example of Use
To query the gate signal source.
SWE:EGAT:SOUR?
> WIF