Anritsu MS2840A - SPUR:SWE:PAUS;SPUR:SWE:PAUS?

Chapter
４
Native Device Message Details
4-293
4
Native Device Message Details
SPUR:SWE:PAUS/SPUR:SWE:PAUS?
Pause before Sweep
Function
This command configures the setting to pause before sweep of each
segment.
Command
SPUR:SWE:PAUS
switch_1_com,switch_2_com,switch_3_com,switch_4_com,swit
ch_5_com,switch_6_com,switch_7_com,switch_8_com,switch_9
_com,switch_10_com,switch_11_com,switch_12_com,switch_13
_com,switch_14_com,switch_15_com,switch_16_com,switch_17
_com,switch_18_com,switch_19_com,switch_20_com
Query
SPUR:SWE:PAUS?
Response
switch_1_res,switch_2_res,switch_3_res,switch_4_res,swit
ch_5_res,switch_6_res,switch_7_res,switch_8_res,switch_9
_res,switch_10_res,switch_11_res,switch_12_res,switch_13
_res,switch_14_res,switch_15_res,switch_16_res,switch_17
_res,switch_18_res,switch_19_res,switch_20_res
Parameter
switch_n_com
Pause before sweep On/Off
ON|1
Pause before sweep.
OFF|0
Not pause before sweep.
switch_n_res
Pause before sweep On/Off
1
Pause before sweep.
0
Pause before sweep.
Details
•
When it is set to On, the dialog box is displayed before measuring the
segment, and the measurement will pause.
•
The measurement does not pause during remote operation. Also, when
it has switched to remote operation during pause, the measurement
will restart.