Chapter
４
Native Device Message Details
4-320
SWE:EGAT:HOLD/SWE:EGAT:HOLD?
Gate Hold
Function
This command sets the time during which gate input is disabled for a set
time, from the first gate input signal until the next gate signal input,
during gate sweep.
Command
SWE:EGAT:HOLD time
Query
SWE:EGAT:HOLD?
Response
time
Suffix code None. Value is returned in s units.
Parameter
time
Offset time
Range 0 to 1 s
Resolution 10 ns
Suffix code NS, US, MS, S
S is used when the suffix code is omitted.
Default 100 µs
Details
This command is not available for MS269x Series.
The Gate Hold (ON/OFF) function is set to ON when the value is
changed with this function.
Example of Use
To set the gate input disable time to 100 ms.
SWE:EGAT:HOLD 100ms
SWE:EGAT:HOLD?
> 0.10000000
To Next Page
Loading...
