Chapter
４
Native Device Message Details
4-174
Details
This command is not available in the following cases:
•
During the Spurious Emission measurement and when Displayed
Segment Mode is set to Auto.
•
During the Spectrum Emission Mask measurement.
Example of Use
To move the zone marker center to 500 points from the screen left edge.
MKZ 500
MKZ?
> 500
MKZF/MKZF?
Zone Marker Frequency (Time)
Function
This command moves the zone marker center to the specified frequency
(time).
Command
MKZF freq,marker
MKZF time,marker
Query
MKZF? marker
Response
freq
Returns a value without a suffix code, in Hz units, and with a
resolution of 0.01 Hz.
time
Returns a value without a suffix code, in
µ
s units, and with a
resolution of 0.01
µ
s.
Parameter
freq
Zone marker center frequency
Range
[MS269xA]
–100 MHz to 6.0 GHz (MS2690A)
–100 MHz to 13.5 GHz (MS2691A)
–100 MHz to 26.6 GHz (MS2692A)
[MS2830A]
–100 MHz to 3.7 GHz (Option 040)
–100 MHz to 6.1 GHz (Option 041)
To Next Page
Loading...
