Anritsu MS2840A - Page 1257

Chapter
４
Native Device Message Details
4-175
4
Native Device Message Details
–100 MHz to 13.6 GHz (Option 043)
–100 MHz to 26.6 GHz (Option 044)
–100 MHz to 43.1 GHz (Option 045)
[MS2840A]
–100 MHz to 3.7 GHz (Option 040)
–100 MHz to 6.1 GHz (Option 041)
–100 MHz to 26.6 GHz (Option 044)
–100 MHz to 44.6 GHz (Option 046)
Resolution 0.01 Hz
Suffix code HZ, KHZ, KZ, MHZ, MZ, GHZ, GZ
Hz is used when omitted.
time
Range –1000 to 1000 s
Resolution 1 ns
Suffix code NS, US, MS, S
MS is used when omitted.
marker
Marker type
1
Marker 1
2
Marker 2
3
Marker 3
4
Marker 4
5
Marker 5
6
Marker 6
7
Marker 7
8
Marker 8
9
Marker 9
10
Marker 10
When omitted Active marker
Details
This command is not available during the Spurious Emission
measurement and when Displayed Segment Mode is set to Auto.
This command is disabled during the Spectrum Emission Mask
measurement.
Example of Use
To move the zone marker center to 100 MHz:
MKZF 100MHZ
MKZF?
> 100000000.00