Anritsu MS2840A - Page 874

Chapter 2 SCPI Device Message Detail
2-864
Table 2.17-3 Parameter List Settings (ACP Measurement) (Cont’d)
Parameter Attribute Name Setting Attribute Value Setting
ACP Carrier Select Number
“ACP Carrier Select Number”
Describes reference carrier
number.
ACP In Band Center
“ACP In Band Center”
Value is described
in Hz units.
ACP Carrier Spacing
“ACP Carrier Spacing”
Value is described
in Hz units.
ACP Carrier BW
“ACP Carrier BW”
Value is described
in Hz units.
ACP In Band FilterType
“ACP In Band FilterType”
“
Rect
”: Rect
“
Nyquist
”: Nyquist
“
Root Nyquist
”: Root Nyquist
ACP In Band Roll-off Factor
“ACP In Band Roll-off Factor”
Value is described
in 0.01 units.
ACP Ofset Ch Bw
“ACP Ofset Ch Bw”
Value is described
in Hz units.
ACP Offset1 Switch
“ACP Offset1 Switch”
“
Off
”: Off
“
On
”: On
ACP Offset2 Switch
“ACP Offset2 Switch”
“
Off
”: Off
“
On
”: On
ACP Offset3 Switch
“ACP Offset3 Switch”
“
Off
”: Off
“
On
”: On
ACP Offset1 Value
“ACP Offset1 Value”
Value is described
in Hz units.
ACP Offset2 Value
“ACP Offset2 Value”
Value is described
in Hz units.
ACP Offset3 Value
“ACP Offset3 Value”
Value is described
in Hz units.
ACP Offset FilterType
“ACP Offset FilterType”
“
Rect
”: Rect
“Nyquist
”: Nyquist
“
Root Nyquist
”: Root Nyquist
ACP Offset Roll-off Factor
“ACP Offset Roll-off Factor”
Value is described
in 0.01 units.
ACP Power Result Type
“ACP Power Result Type”
“
Ofs.
”: Offset
“
Carrier
”: Carrier
Auto Sweep Time Select
“Auto Sweep Time Select”
“
Normal
”: Normal
“
Fast
”: Fast