Anritsu MS2840A - Page 356

Chapter 2 SCPI Device Message Details
2-346
When omitted: CS:7MHz Class:2
When Standard is set to NXDN
(ACP Measurement)
<pattern> Parameter to be set
BW-6_25KHZ
BW-6.25kHz
BW-12_5KHZ
BW-12.5kHz
When omitted: BW-12.5kHz
When Standard is set to NXDN
(Spectrum Emission Mask Measurement)
<pattern> Parameter to be set
47CFR-E_6_25KHZ
47CFR-E_6.25kHz
47CFR-D_12_5KHZ
47CFR-D_12.5kHz
When omitted: 47CFR-D_12.5kHz
Details
This command is not available when Standard is set to Off.
Example of Use
To set the ACP measurement parameter type to 3GPP W-CDMA Uplink.
RAD:STAN:LOAD ADJ,UPLINK