Anritsu MS2840A - Page 1038

Chapter
３
Native Device Message List
3-12
Table 3.6-1 Marker setting messages (Cont’d)
Function Command Query Response Remarks
Active Marker
MKACT marker MKACT? marker
Relative To
CALC:MARK:REF
marker,integer
CALC:MARK:REF? marker integer
Marker List
CALC:MARK:TABL
switch_com
CALC:MARK:TABL? switch_res
switch_com :
= ON|OFF|1|0
Spot Line
CALC:MARK:SLIN
switch_com
CALC:MARK:SLIN? switch_res
switch_com :
= ON|OFF|1|0
Couple Zone
CALC:MARK:COUP:ZONE
switch_com
CALC:MARK:COUP:ZONE? switch_res
switch_com :
= ON|OFF|1|0
Marker Result
MKLTYPE type_com MKLTYPE? type_res
type_com :
= INT|TOTAL|DENS|AVG|PEAK
Zone Width Type
CALC:MARK:WIDT:TYPE
n,type
CALC:MARK:WIDT:TYPE?
n
Type
n =
Marker number
type : Zone waveform
= ZONE|SPOT
Frequency Counter Gate Time
CALC:MARK:FCO:GAT n,
time
CALC:MARK:FCO:GAT? n time
n =
Marker number
Frequency Counter State
CALC:MARK:FCO n,
switch
CALC:MARK:FCO? n switch
n =
Marker number
switch : = ON|OFF|1|0
Frequency Counter Query
---
CALC:MARK:FCO:X? n
freq
n =
Marker number
Marker Tracking
CALC:MARK:TRCK switch
CALC:MARK:TRCK? switch
switch : = ON|OFF|1|0