Anritsu MS2840A - Page 1174

Chapter
４
Native Device Message Details
4-92
tracedata_1,tracedata_2•••••tracedata_m
(n=23 to 42)
Parameter
range_n
Segment number of the detected spurious
spur_n
Spurious number
number
Number of the detected spurious
–999.0 is returned when an error occurs/no
measurement is performed.
freq_n
Frequency of Spurious
Only one value is returned when Marker Result
Type is Worst.
Values have no suffix code, are in Hz units, and
have 0.01 Hz Resolution.
–999999999999 is returned when an error
occurs/no measurement is performed.
peak_n
Absolute power of Spurious
Only one value is returned when Marker Result
Type is Worst.
Values have no suffix code, are in Hz units, and
have 0.01 Hz Resolution.
–999.0 is returned when an error occurs/no
measurement is performed.
margin_n
Relative power from the limit line of Spurious
Only one value is returned when Marker Result
Type is Worst.
Values have no suffix code, are in Hz units, and
have 0.01 Hz Resolution.
–999.0 is returned when an error occurs/no
measurement is performed.
limit_n
Power value of the limit line of Spurious
Only one value is returned when Marker Result
Type is Worst.
Values have no suffix code, are in Hz units, and
have 0.01 Hz Resolution.
–999.0 is returned when an error occurs/no
measurement is performed.
judge_n
Limit line judges the detected spurious as Pass
or Fail.
0 is returned when judged as Pass, and 1 is
returned when judged as Fail.