Anritsu MS2840A - Page 264

Chapter 2 SCPI Device Message Details
2-254
2 ms (Option 041)
4 ms (Option 043)
89 ms (Option 044)
86 ms (Option 045)
[MS2840A]
1 ms (Option 040)
2 ms (Option 041)
89 ms (Option 044)
86 ms (Option 046)
Details
This command is not available when in FFT sweep.
This command is not available during the Spectrum Emission Mask or
the Spurious Emission measurement.
This command is not available when Internal Signal Generator Control
On/Off is On.
Example of Use
To set the sweep time to 100 ms.
SWE:TIME 0.1
Related command
This command has the same function as the following commands.
[:SENSe]:ACPower:SWEep:TIME
[:SENSe]:CHPower:SWEep:TIME
[:SENSe]:OBWidth:SWEep:TIME
[:SENSe]:BPOWer|:TXPower:SWEep:TIME