Anritsu MS2840A - Page 335

2.8 Measure Function
2-325
2
SCPI Device Message Details
When Standard is set to W-CDMA Uplink (Channel Power
measurement)
<pattern>
Parameter to be set
UPLINK
3GPP W-CDMA Uplink, Mean Power
measurement
MEAN
3GPP W-CDMA Uplink, Mean Power
measurement
RRCFILTER 3
GPP W-CDMA Uplink, RRC Filtered Power
measurement
When omitted: 3GPP W-CDMA Uplink, Mean Power
measurement
When Standard is set to W-CDMA Uplink (Spectrum Emission Mask
measurement)
<pattern>
Parameter to be set
UPLINK
3GPP W-CDMA Uplink, Spectrum Emission
Mask measurement (Uplink)
ADD
3GPP W-CDMA Uplink, Spectrum Emission
Mask measurement (Uplink (Additional)
When omitted: 3GPP W-CDMA Uplink, Spectrum Emission
Mask measurement (Uplink)
When Standard is set to W-CDMA Downlink (ACP measurement)
<pattern>
Parameter to be set
DOWNLINK
3GPP W-CDMA Downlink, ACP measurement
(Single Carrier)
SINGLECARR
3GPP W-CDMA Downlink, ACP measurement
(Single Carrier)
2CARR
3GPP W-CDMA Downlink (2 Carriers)
3CARR
3GPP W-CDMA Downlink (3 Carriers)
4CARR
3GPP W-CDMA Downlink (4 Carriers)
When omitted: 3GPP W-CDMA Downlink, ACP measurement
(Single Carrier)
When Standard is set to W-CDMA Downlink (Burst Average Power
measurement)
<pattern>
Parameter to be set
MEAN
3GPP W-CDMA Downlink, Mean Power
measurement
When omitted: 3GPP W-CDMA Downlink, Mean Power
measurement