2
SCPI Device Message Details
Details
This command is not available during the Spectrum Emission Mask
measurement or the Spurious Emission measurement.
Frequency span cannot be set to 0 Hz when Internal Signal Generator
Control On/Off is On.
Frequency span cannot be set to 0 Hz when the N dB Bandwidth
measurement function is On.
Example of Use
To set the frequency span to 1 GHz.
FREQ:SPAN 1GHZ
Related command
This command has the same function as the following commands.
[:SENSe]:ACPower:FREQuency:SPAN
[:SENSe]:CHPower:FREQuency:SPAN
[:SENSe]:OBWidth:FREQuency:SPAN
To Next Page
Loading...
