2.17 Configuring Batch Measurement Settings
2-867
2
SCPI Device Message Details
Since the settings are done in sequence from the top, be careful about the
description order when setting parameters that have relationships of
dependence. Also, if a value that is either out of the setting range or that
cannot be set has been input, that setting is ignored.
Table 2.17-5 Parameter List Settings (OBW Measurement)
Parameter Attribute Name Setting Attribute Value Setting
Center Frequency
“Center Freq.”
Value is described
in Hz units.
Spurious Mode
“Frequency Band Spurious
Mode”
“
Normal
”: Normal
“
Spurious
”: Spurious
Span Frequency
“Span Freq.”
Value is described
in Hz units.
Reference Level
“Reference Level”
Value is described
in dBm units.
Reference Level Offset
“Reference Level Offset”
“
Off
”: Off
Reference Level Offset Value
“Reference Level Offset
Value”
Value is described
in 0.01 dB units.
RBW Auto/Manual
“RBW Switch”
“
Manual
”: Manual
VBW Auto/Manual
“VBW Switch”
“
Auto
”: Auto
“
Manual
”: Manual
Sweep Time Auto/Manual
“Sweep Time Switch”
“Manual”: Manual
Attenuator Auto/Manual
“ATTN Switch”
“
Auto
”: Auto
“
Manual
”: Manual
RBW
“RBW Value”
“
100Hz
”: 100 Hz
“
300Hz
”: 300 Hz
“
500Hz
”: 500 Hz
“
1kHz
”: 1 kHz
“
3kHz
”: 3 kHz
“
10kHz
”: 10 kHz
“
30kHz
”: 30 kHz
“
50kHz
”: 50 kHz
“
100kHz
”: 100 kHz
“
300kHz
”: 300 kHz
“
1MHz
”: 1 MHz
“
2MHz
”: 2 MHz
“
3MHz
”: 3 MHz
“
5MHz
”: 5 MHz
“
10MHz
”: 10 MHz
“
20MHz
”: 20 MHz
To Next Page
