Anritsu MS2840A - Page 894

Chapter 2 SCPI Device Message Detail
2-884
Table 2.17-7 Parameter List Settings (SEM Measurement) (Cont
’
d)
Parameter Attribute Name Setting Attribute Value Setting
SEM Offset1 Detection
“SEM Offset1 Detection”
“
Pos & Neg
”:
Pos & Neg
“
Positive
”: Positive
“
Negative
”: Negative
“
Sample
”: Sample
“
RMS
”: RMS
SEM Offset2 Detection
“SEM Offset2 Detection”
Same as above
SEM Offset3 Detection
“SEM Offset3 Detection”
Same as above
SEM Offset4 Detection
“SEM Offset4 Detection”
Same as above
SEM Offset5 Detection
“SEM Offset5 Detection”
Same as above
SEM Offset6 Detection
“SEM Offset6 Detection”
Same as above
SEM Offset1 TracePoint
“SEM Offset1 TracePoint”
Describes the number of
trace points.
SEM Offset2 TracePoint
“SEM Offset2 TracePoint”
Same as above
SEM Offset3 TracePoint
“SEM Offset3 TracePoint”
Same as above
SEM Offset4 TracePoint
“SEM Offset4 TracePoint”
Same as above
SEM Offset5 TracePoint
“SEM Offset5 TracePoint”
Same as above
SEM Offset6 TracePoint
“SEM Offset6 TracePoint”
Same as above
SEM Offset1 ABS1 Start Level
“SEM Offset1 ABS1 Start
Level”
Value is described
in 0.01 dBm units.
SEM Offset2 ABS1 Start Level
“SEM Offset2 ABS1 Start
Level”
Same as above
SEM Offset3 ABS1 Start Level
“SEM Offset3 ABS1 Start
Level”
Same as above
SEM Offset4 ABS1 Start Level
“SEM Offset4 ABS1 Start
Level”
Same as above
SEM Offset5 ABS1 Start Level
“SEM Offset5 ABS1 Start
Level”
Same as above
SEM Offset6 ABS1 Start Level
“SEM Offset6 ABS1 Start
Level”
Same as above