Anritsu MS2840A - Page 896

Chapter 2 SCPI Device Message Detail
2-886
Table 2.17-7 Parameter List Settings (SEM Measurement) (Cont
’
d)
Parameter Attribute Name Setting Attribute Value Setting
SEM Offset1 REL Start Level
“SEM Offset1 REL Start
Level”
Value is described
in 0.01 dBm units.
SEM Offset2 REL Start Level
“SEM Offset2 REL Start
Level”
Same as above
SEM Offset3 REL Start Level
“SEM Offset3 REL Start
Level”
Same as above
SEM Offset4 REL Start Level
“SEM Offset4 REL Start
Level”
Same as above
SEM Offset5 REL Start Level
“SEM Offset5 REL Start
Level”
Same as above
SEM Offset6 REL Start Level
“SEM Offset6 REL Start
Level”
Same as above
SEM Offset1 REL Stop Level
“SEM Offset1 REL Stop
Level”
Value is described
in 0.01 dBm units.
SEM Offset2 REL Stop Level
“SEM Offset2 REL Stop
Level”
Same as above
SEM Offset3 REL Stop Level
“SEM Offset3 REL Stop
Level”
Same as above
SEM Offset4 REL Stop Level
“SEM Offset4 REL Stop
Level”
Same as above
SEM Offset5 REL Stop Level
“SEM Offset5 REL Stop
Level”
Same as above
SEM Offset6 REL Stop Level
“SEM Offset6 REL Stop
Level”
Same as above