Anritsu MS2840A - Page 903

2.17 Configuring Batch Measurement Settings
2-893
2
SCPI Device Message Details
Table 2.17-9 Parameter List Settings (Spurious Emission Measurement)
Parameter Attribute Name Setting Attribute Value Setting
Reference Level
“Reference Level”
Value is described
in dBm units.
Reference Level Offset
“Reference Level Offset”
“
On
”: On
“Off”: Off
Reference Level Offset Value
“Reference Level Offset
Value”
Value is described
in 0.01 dB units.
Storage Mode
“Storage Mode A”
“
Lin Average
”: Lin Average
“
Average
”: Average
“
Max Hold
”: Max Hold
“
Min Hold
”: Min Hold
“
Off
”: Off
Trigger Switch
“Trigger Switch”
“
Off
”: Off
“
On
”: On
Trigger Source
“Trigger Source”
“
Video
”: Video
“
External
”: External
“
SG Marker
”: SG Marker
“
Wide IF Video
”:
Wide IF Video
“
BBIF
”: BBIF
Trigger Slope
“Trigger Slope”
“
Rise
”: Rise
“
Fall
”: Fall
Trigger Level (Video)
“Trigger Level(Video)Log”
Value is described
in dBm units.
Trigger Level (Wide IF Video)
“Trigger Level(Wide)”
Value is described
in dBm units.
Gate Sweep
“Gate Sweep”
“
Off
”: Off
“
On
”: On
Gate Source
“Gate Source”
“
External
”: External
“
SG Marker
”: SG Marker
“
Wide IF Video
”:
Wide IF Video
“
BBIF
”: BBIF
Gate Delay
“Gate Delay”
Value is described
in ns units.
Gate Length
“Gate Length”
Value is described
in ns units.
Gate Level (Wide IF Video)
“Gate Level(Wide)”
Value is described
in dBm units.
Gate Slope
“Gate Slope”
“
Rise
”: Rise
“
Fall
”: Fall