Anritsu MS2840A - Page 906

Chapter 2 SCPI Device Message Detail
2-896
Table 2.17-9 Parameter List Settings (Spurious Emission Measurement) (Cont
’
d)
Parameter Attribute Name Setting Attribute Value Setting
Spurious Segment1 Start Freq
“Spurious Start Freq1”
Value is described
in Hz units.
Spurious Segment2 Start Freq
“Spurious Start Freq2”
Same as above
Spurious Segment3 Start Freq
“Spurious Start Freq3”
Same as above
Spurious Segment4 Start Freq
“Spurious Start Freq4”
Same as above
Spurious Segment5 Start Freq
“Spurious Start Freq5”
Same as above
Spurious Segment6 Start Freq
“Spurious Start Freq6”
Same as above
Spurious Segment7 Start Freq
“Spurious Start Freq7”
Same as above
Spurious Segment8 Start Freq
“Spurious Start Freq8”
Same as above
Spurious Segment9 Start Freq
“Spurious Start Freq9”
Same as above
Spurious Segment10 Start Freq
“Spurious Start Freq10”
Same as above
Spurious Segment11 Start Freq
“Spurious Start Freq11”
Same as above
Spurious Segment12 Start Freq
“Spurious Start Freq12”
Same as above
Spurious Segment13 Start Freq
“Spurious Start Freq13”
Same as above
Spurious Segment14 Start Freq
“Spurious Start Freq14”
Same as above
Spurious Segment15 Start Freq
“Spurious Start Freq15”
Same as above
Spurious Segment16 Start Freq
“Spurious Start Freq16”
Same as above
Spurious Segment17 Start Freq
“Spurious Start Freq17”
Same as above
Spurious Segment18 Start Freq
“Spurious Start Freq18”
Same as above
Spurious Segment19 Start Freq
“Spurious Start Freq19”
Same as above
Spurious Segment20 Start Freq
“Spurious Start Freq20”
Same as above