Juniper ACX2000 Configuration Guide

Table 91: jnxSoamLmCfgTable (continued)
DescriptionObject IDObject
Specifies the Maintenance Association End Point Identifier
of another MEP in the same Maintenance Association to
which the SOAM LM frame is to be sent.
This address will be used if the value of the column
jnxSoamLmDestIsMepId is 'true'. A value of zero means
that the destination MEP ID has not been configured.
This object is only valid for the entity transmitting the Loss
Measurement frames, types 'lmLmm' and 'lmSlm'. It is
not applicable for the 'lmCcm' type.
This object can only be written at row creation time and
cannot be modified once it has been created.
JnxSoamLmCfgEntry
13
jnxSoamLmCfgDestMepId
Specifies whether the MEP ID or the MAC address of the
destination MEP is used for SOAM LM frame transmission.
A value of 'true' indicates that MEPID of the target MEP
is used for SOAM LM frame transmission. A value of 'false'
indicates that the MAC address of the target MEP is used
for SOAM LM frame transmission.
This object is only valid for the entity transmitting the Loss
Measurement frames, types 'lmLmm' and 'lmSlm'. It is
not applicable for the 'lmCcm' type.
This object can only be written at row creation time and
cannot be modified once it has been created.
JnxSoamLmCfgEntry
14
jnxSoamLmCfgDestIsMepId
Specifies the type of start time of the SOAM LM session.
The start time can be disabled (none), immediate, relative,
or fixed.
The value of 'none' is illegal and a write error will be
returned if this value is used.
The value of 'immediate' starts the SOAM LM session
when the jnxSoamLmCfgEnabled is true.
The value of 'fixed' starts the SOAM LM session when the
jnxSoamLmFixedStartDateAndTime is less than or equal
to the current system date and time and
jnxSoamLmCfgEnabled is true. This value is used to
implement an On-Demand fixed time PM session.
The value of 'relative' starts the SOAM LM session when
the current system date and time minus the
jnxSoamLmRelativeStartTime is greater than or equal to
the system date and time when the
jnxSoamLmStartTimeType object was written and
jnxSoamLmCfgEnabled is true. This value is used to
implement an On-Demand relative time PM session.
This object can only be written at row creation time and
cannot be modified once it has been created.
JnxSoamLmCfgEntry
15
jnxSoamLmCfgStartTimeType
1181Copyright © 2017, Juniper Networks, Inc.
Chapter 34: Configuring Operations, Administration, and Management (OAM)

Juniper ACX2000 Specifications

General

Brand	Juniper
Model	ACX2000
Category	Network Router
Language	English