Juniper ACX2000 Configuration Guide

Table 106: Parameters for test-profile Configuration (continued)
DescriptionParameters
Size of the test packet.
The valid packet sizes are 64, 68, 72, 128, 256, 512, 768, 1024, 1280, 1518, 1522, 1600, 1728,
2496, 3584, 4016, 9104, and 9136 bytes.
packet-size
Define the maximum bandwidth limit, in kilobits per second (kbps).
Range: 1,000 kpbs through 1,000,000 kbps.
bandwidth-kbps
Specify the step percentage for frame-loss tests.
Default: 10 percent
Range: 1 through 100 percent
step-percent
Table 107 on page 1342 lists the parameters for configuring a test-name at initiator and
reflector.
Table 107: Parameter for test-name configuration
DescriptionParameters
When the check-test-interface-mtu parameter is configured, the parameter validates the MTU
size of the test packets with the MTU size configured on the interface and the following would be
the behavior for initiator and reflector modes:
•
On the initiator, if the MTU size of the test packet is larger than the MTU size configured on the
interface, then the RFC2544-based benchmarking test fails to start.
•
On the reflector, if the test packets coming to the reflector does not confirm to the MTU size
configured on the interface, then these test packets do not get reflected and are dropped.
check-test-interface-mtu
Specify the destination IPv4 address.
This parameter is mandatory when family inet is specified and optional when family ccc is specified.
If a value is not specified, then by default 192.168.1.20 is used.
NOTE: This parameter is not supported on ACX5048 and ACX5096 routers.
destination-ipv4-address
Specify the destination MAC address. For example, 0011.2233.4455.
This parameter cannot be used when family inet is specified.
This parameter is optional when family ccc is specified. If not specified, then the default value of
0x00:0x11:0xAE:0x92:0x2F:0x28 is used.
destination-mac-address
Specify the destination UDP port number for the test frames. Default: 4041.
NOTE: This parameter is not supported on ACX5048 and ACX5096 routers.
destination-udp-port
Specify the test direction (egress | ingress). This parameter is valid only when family ccc and bridge.
This parameter is mandatory for mode ethernet-loopback
direction
Copyright © 2017, Juniper Networks, Inc.1342
ACX Series Universal Access Router Configuration Guide

Juniper ACX2000 Specifications

General

Brand	Juniper
Model	ACX2000
Category	Network Router
Language	English