Juniper ACX2000 Configuration Guide

Table 107: Parameter for test-name configuration (continued)
DescriptionParameters
Disable signature verification on the received test frames.disable-signature-check
Specify the value of the Differentiated Services (DiffServ) field. For example, 001111.
If a value is not specified, then '0' is used in IP header.
NOTE: This parameter is not supported on ACX5048 and ACX5096 routers.
dscp-code-points
Configure the test family (bridge | ccc | inet).
This parameter is mandatory for mode ethernet-loopback
family
Specify the forwarding class to be used for test frames.forwarding-class
If specified, a prefix that moves to the down state causes the corresponding tests to be stopped.
NOTE: This parameter is not supported on ACX5048 and ACX5096 routers.
halt-on-prefix-down
When the ignore-test-interface-state parameter is configured for RFC2544 benchmarking tests,
the test continues to run even if there are any occurrences of interface up or down events. This is
applicable to both initiator and reflector test modes.
ignore-test-interface-state
If specified, only the data traffic corresponding to the test session is interrupted, rest of the data
traffic flow sent to and from the UNI port under test on the service are not affected.
NOTE: This parameter is not supported on ACX5048 and ACX5096 routers.
in-service
CFI bit used in the inner VLAN tag.
NOTE: This parameter is not supported on ACX5048 and ACX5096 routers.
ivlan-cfi
Configure inner VLAN ID for the test frames.
This parameter is valid only for family ccc mode.
NOTE: This parameter is not supported on ACX5048 and ACX5096 routers.
ivlan-id
Configure the priority value for the IEEE 802.1p bit in the inner VLAN tag.
Range: 0 through 7.
NOTE: This parameter is not supported on ACX5048 and ACX5096 routers.
ivlan-priority
Specify the test mode (ethernet-loopback, initiate-and-terminate, or reflect).
•
ethernet-loopback—Test frames are loopbacked to the measuring device after the source MAC
address and the destination MAC addresses are swapped.
•
initiate-and-terminate—Test frames are initiated and terminated at the same end. If you specify
this mode, then a reflector should be configured on the peer end to bring back the test frames.
•
reflect—Test frames are reflected on the chosen service.
mode
1343Copyright © 2017, Juniper Networks, Inc.
Chapter 37: Configuring RFC 2544-Based Benchmarking Tests

Juniper ACX2000 Specifications

General

Brand	Juniper
Model	ACX2000
Category	Network Router
Language	English