Juniper ACX2000

user@host# set mode reflect
14. Configure the address type family, ccc, for the benchmarking test.
[edit services rpm rfc2544-benchmarking tests test-name test1]
user@host# set family ccc
15. Specify the direction of the interface on which the test must be run, which is UNI in
this example.
[edit services rpm rfc2544-benchmarking tests test-name test1]
user@host# set direction uni
Results
In configuration mode, confirm your configuration on Router A and Router B by entering
the show command. If the output does not display the intended configuration, repeat
the configuration instructions in this example to correct it.
Configuring Benchmarking Test Parameters on Router A:
[edit interfaces]
ge-0/0/0 {
vlan-tagging;
unit 0 {
vlan-id 101;
family inet {
address 200.0.0.1/24;
}
}
}
[edit services rpm]
rfc2544-benchmarking {
profiles {
test-profile throughput {
test-type throughput
packet-size 64;
test-duration 20m;
bandwidth-kbps 500;
}
}
tests {
test-name test1 {
interface ge-0/0/0.1;
test-profile throughput;
mode initiate,terminate;
family inet;
dest-address 200.0.0.2
udp-port 4001;
}
}
}
Copyright © 2017, Juniper Networks, Inc.1382
ACX Series Universal Access Router Configuration Guide