Configuring Benchmarking Test Parameters on Router B:
[edit interfaces]
ge-0/0/4 {
vlan-tagging;
unit 0 {
encapsulation vlan-ccc;
vlan-id 101;
}
}
[edit services rpm]
rfc2544-benchmarking {
# Note, When in reflector mode, test profile is not needed
tests {
test-name test1 {
interface ge-0/0/4.1;
mode reflect;
family ccc;
direction uni;
}
}
}
After you have configured the device, enter the commit command in configuration mode.
Verifying the Results of the Benchmarking Test for UNI Direction of an Ethernet Pseudowire
Service
Examine the results of the benchmarking test that is performed on the configured service
between Router A and Router B.
•
Verifying the Benchmarking Test Results on page 1383
Verifying the Benchmarking Test Results
Purpose Verify that the necessary and desired statistical values are displayed for the benchmarking
test that is run on the configured service between Router A and Router B.
Action In operational mode, enter the run show services rpm rfc2544-benchmarking (aborted-tests
| active-tests | completed-tests | summary) command to display information about the
results of each category or state of the RFC 2544-based benchmarking test, such as
aborted tests, active tests, and completed tests, for each real-time performance
monitoring (RPM) instance.
Meaning The output displays the details of the benchmarking test that was performed. For more
information about the run show servicesrpm rfc2544-benchmarking operational command,
see show services rpm rfc2544-benchmarking in the CLI Explorer.
1383Copyright © 2017, Juniper Networks, Inc.
Chapter 37: Configuring RFC 2544-Based Benchmarking Tests
To Next Page
Loading...
Need help?
General
